- set_test_options(+Options)
- Specifies how to deal with test suites. Defined options are:
- load(+Load)
- Whether or not the tests must be loaded. Values are
never, always, normal (only if not optimised)
- run(+When)
- When the tests are run. Values are
manual, make
or make(all).
- format(+Mode)
- Currently one of
tty or log. tty uses terminal
control to overwrite successful tests, allowing the
user to see the currently running tests and output
from failed tests. This is the default of the output
is a tty. log prints a full log of the executed
tests and their result and is intended for non-interactive
usage.
- output(+When)
- If
always, emit all output as it is produced, if never,
suppress all output and if on_failure, emit the output
if the test fails.
- show_blocked(+Bool)
- Show individual blocked tests during the report.
- occurs_check(+Mode)
- Defines the default for the
occurs_check flag during
testing.
- cleanup(+Bool)
- If
true (default =false), cleanup report at the end
of run_tests/1. Used to improve cooperation with
memory debuggers such as dmalloc.
- jobs(Num)
- Number of jobs to use for concurrent testing. Default
is one, implying sequential testing.
- timeout(+Seconds)
- Set timeout for each individual test. This acts as a
default that may be overuled at the level of units or
individual tests. A timeout of 0 or negative is handled
as inifinite.
